161
Mode........................................... TFTP
Set Server IP.................................. 172.16.1.102
Path........................................... ./
Filename....................................... QNOS-ly8-5.4.00.32.stk
Data Type...................................... Code
Destination Filename........................... backup
Management access will be blocked for the duration of the transfer
Are you sure you want to start? (y/n) y
5. After the transfer completes, activate the new image so that it becomes the active image after the
switch resets.
(QCT) #boot-system opcode backup
Activating image backup ..
6. View information about the current image.
(QCT) #show bootvar
Image Descriptions
active :
backup :
Images currently available on Flash
---- ------------ ------------ ----------------- -----------------
unit active backup current-active next-active
---- ------------ ------------ ----------------- -----------------
1 5.4.0.31 5.4.0.32 5.4.00.31 5.4.0.32
7. Copy the running configuration to the startup configuration to save the current configuration to NVRAM.
(QCT) #copy running-config startup-config
This operation may take a few minutes.
Management interfaces will not be available during this time. Are you sure you want to save?
(y/n)y
Configuration Saved!
To Next Page
Loading...
Need help?
General