Pronto! 482/486/682/863 8-23
2 Feed the label strip over the guide axle (9) and under the roller (8) to the
rewind axle (7).
3 Attach the label strip appropriately to the rewind axle by sliding the
clamp (5) over the label strip with the clamp set in the groove of the
rewind axle (7).
4 Slide the clamp (5) as far as possible towards the disc (6).
5 Slide the flange on ER4 (4) onto the rewind axle so that it slightly touches
the label strip. The label strip must be able to move between the disc and
the flange.
6 Tighten the knurled screw (3) on the flange.
7 Switch on the rewinder on the power switch.
To Next Page
Loading...