QuickLabel Systems pronto! 486 - Adjustment

Pronto! 482/486/682/863 8-61
3 Tighten the screw (3).
4 Mount the rear cover.
5 Put the antistatic brush (5) with the lower elongated hole onto the thread
of screw (3)
6 Fix the antistatic brush in the upper elongated hole with the screw (6) at
the drilling (4).
Adjustment
1 Load label material.
2 Loosen the screw (6).
3 Move the antistatic brush (5) as close as possible to the labels without
touching them with fibers (7) during printing.
4 Tighten the screw (6).