QuickLabel Systems pronto! 486 - Maintenance Plan

11-2 Cleaning and basic maintenance
Maintenance plan
Maintenance task When
General cleaning (see General cleaning on
page 11-3)
as necessary
Clean print roller (see Cleaning the print
roller on page 11-4)
each time the label roll is changed or
when the print image and label
transport are adversely affected.
Clean printhead (see Cleaning the
printhead on page 11-5)
direct thermal printing: each time the
label roll is changed
thermal transfer printing: each time the
transfer ribbon is changed
or when the print image is adversely
affected
Clean label sensor (see Cleaning the label
sensor on page 11-6)
when the label roll is changed
Replace printhead (Replacing the
printhead on Pronto! 482/486 models on
page 11-7)
when errors in the print image occur
Replace print roller and rewind assist
roller (see Replacing the print roller and
rewind assist roller on page 11-12)
when print image and label transport
are adversely affected