8-38 Accessories
The print of a label is executed if:
• A print job is available
• There is no label waiting to be removed from peel position
• The trigger switch sends the XSTART signal
This operation mode requires that there is a contact between PIN13 (STA) and
PIN12 (GND).
Print on Demand with Releasing via an External Control
In this operation mode an external control is connected to the peripheral
interface of the Present Sensor PS6.
After removing the label printing of the next label will be executed by the
start signal from an external control device.
The print of a label is executed if:
• A print job is available
• There is no label waiting to be removed from peel position
• The external control sends the XSTART signal
This operation mode requires that there is a contact between PIN13 (STA) and
PIN12 (GND).
To Next Page
Loading...