6-12 Loading media
Removing and installing the rewind guide
plate, dispense plate or tear-off plate
To convert the printer for use in another operating mode, a rewind guide
plate, a dispense plate or a tear-off plate may need to be installed.
Note: For printer versions with a locking system on the rewind assist roller,
the locking system on the rewind assist roller must be removed (see Removing
and installing the locking system on page 6-13) for operation in Rewind mode
before installation of the rewind guide plate.
Removing a plate
1 Loosen screws (2) several
turns.
2 Slide plate (1) to the right and
remove it.
Installing a plate
1 Place plate (1) onto the screws
(2) and slide to the left
completely.
2 Tighten screws (2).
To Next Page
Loading...