Raven DirecSteer - Page 176

Chapter7
Code ID Description Recommended Actions
voltage.
1. Check cabling for broken or frayed wiring.
2. Check the machine battery voltage.
628
.2
NVM (non-volat-
ile memory)
warning.
1. Cycle power to the machine.
2. If the error persists, contact your local Raven
dealer or the Raven Technical Service team.
.31
NVM (non-volat-
ile memory)
error.
1. Cycle power to the machine.
2. If the error persists, contact your local Raven
dealer or the Raven Technical Service team.
630 .13
SCU (steering
controller
unit)not cal-
ibrated.
Complete the tuneset calibration wizard to calibrated
the SCU, HDU, or IDU. Refer to Initial Tuneset Cal-
ibration for assistance with completing the profile cal-
ibration wizard.
701 .2
Auto resume
error.
Resume switch is stuck ON.
1. Check the resume switch and test functionality in
the universal terminal (UT). Review the "Step
Response Test" on page175 for assistance with
testing the switch.
2. Check resume switch cabling and that cable con-
nections are properly seated.
702 .1 Master OFF. Toggle the master switch to the ONposition.
1385 .11
Node tem-
perature error.
Temperature within the ECUexceeds the operational
temperature range. If the error persists, contact your
local Raven dealer or the Raven Technical Service
team.
1504
.14
OP (operator
presence) active.
The operator override sensor is currently OFF and does
not detect an operator in the operator seat. Review the
"Step Response Test" on page175 for assistance with
testing the operator presence sensor.
.31
Operator pres-
ence warning.
The operator override sensor is OFF. The steering sys-
tem is about to disengage. Review the "Step Response
Test" on page175 for assistance with testing the oper-
ator presence sensor.
162