9
Manual No. 016-0171-148 155
Using AccuBoom™
3. Select the Enable AccuBoom option to allow the AccuBoom feature to automatically control boom or
implement sections. Leaving this option blank will disable AccuBoom. Once the Enable AccuBoom option is
selected, the AccuBoom screen will appear similar to the following:
4. Leave the ‘Use Spray Zone Map’ option deselected to use Standard AccuBoom section control only. See
the AccuBoom™ Modes section on page 156 for more information on the AccuBoom modes.
Touch the Accept icon and skip to step 7 if Standard AccuBoom is the desired mode of operation for this
job. Proceed to step 6 to setup a spray zone map for this job.
5. Select the ‘Use Spray Zone Map’ option to enable the spray zone mapping mode.
The Start Job - Select Spray Zone Map screen is displayed when the ‘Use Spray Zone Map’ option is
enabled.
a. Select the name of a previously saved spray zone map to use with this job and touch the accept icon
to return to the Start Job - Verify Settings screen.
b. To create a new map, touch the Create New icon and enter a name for the spray zone map that will be
created within the job.
Note: Spray zone maps and map file names cannot begin with a space.
6. Touch the Accept icon to save the entered name and return to the Verify Settings screen.
7. Verify the other available settings or features are setup correctly before beginning the job.
To Next Page
Loading...
Need help?
General
