3-22 Raychart 425 Chartplotter
2. Use the trackpad to position the cursor as required.
3. Press
ENTER to start the GoTo, or CLEAR to cancel the operation.
A temporary waypoint is placed at the cursor position and navigation
proceeds towards it. The temporary waypoint is shown as a square with a
dot in it’s centre and is connected to the vessel’s starting position by a
dotted line.
On arrival, the arrival alarm is sounded and the arrival pop-up box is
displayed.
Note: The temporary waypoint is not added to the waypoint list; when the
GoTo is complete, or is stopped, the temporary waypoint is erased.
Go to a Port
You can navigate directly to the nearest port or to a selected port or
facility.
➤ To navigate directly to selected port:
1. Press the
GOTO key and select GOTO PORT to display the Port List.
2. Use trackpad up/down to select the required port and press
ENTER to
start the GoTo, or
CLEAR to cancel the operation.
A dotted line is drawn between the current vessel position and the target
waypoint which is placed at the port. The line remains fixed on the screen
as the vessel moves.
Bearing, Range and Cross Track Error are calculated for the target
waypoint in the same manner as for any other Goto or Follow function.
On arrival, the arrival alarm is sounded and the arrival pop-up box is
displayed.
➤ To navigate directly to the nearest port or facility:
1. Press the
GOTO key and select GOTO NEAREST to display the list.
The list shows the eight nearest places where the selected facility
exists, in order of distance. The bearing and range (in selected units)
for each one is shown.
2. Use trackpad up/down to select the required destination and press
ENTER to start the GoTo, or CLEAR to cancel the operation.
The operation is conducted in the same manner as for
GOTO PORT above.
To Next Page
Loading...
