Chapter 3: Operation 3-7
Figure 3-13: Waypoint List Function Bar
4. Select EDIT WAYPOINT; the waypoint edit functions are displayed
(Figure 3-14):
Figure 3-14: Waypoint Edit Functions
5. To edit the waypoint name, select EDIT NAME; the cursor is placed in
the name field of the selected waypoint.
i. Edit the name as previously described (up to eight characters).
6. To edit the waypoint symbol, select
EDIT SYMBOL.
i. Use trackpad left/right to highlight the required symbol.
ii. Press
ENTER to accept the choice or CLEAR to abort the operation.
7. To change the waypoint’s position, select
EDIT POSITION. The cursor
is placed in the Position field in the Waypoint List.
i. Use trackpad left/right to select the latitude/longitude fields.
ii. Use trackpad up/down to scroll through and edit the values.
iii.When editing is complete, press
ENTER to save the new position.
Erasing Waypoints
Note: A waypoint that is the target waypoint or waypoints that are also
used in any saved route(s) cannot be erased. If an attempt is made to
erase a waypoint that is used in a saved route, the warning “
WAYPOINT IS
USED IN ROUTE(S) AND CANNOT BE ERASED
” is displayed.
➤ To delete a waypoint using the cursor:
1. Place the cursor over the waypoint; see Selecting a Waypoint on
page 3-4.
2. Select
WAYPOINT OPTIONS and press ENTER to display the Edit Way-
point function bar.
3. Select
ERASE WAYPOINT. A warning box appears. Press ENTER to
erase or
CLEAR to retain. If erased, the waypoint list is updated and
the screen is cleared.
To Next Page
Loading...
Need help?
General