4-4 Raychart 425 Chartplotter
Date Format
Set the preferred date format (DD/MM/YY or MM/DD/YY). The selected
setting is retained when the unit switched off. The Default is
DD/MM/YY.
Time Offset
To display local time, use the trackpad to change from UTC to the required
time offset. This can be up to ±13 hours, in 1 hour steps. The default is
UTC.
Language
Select the language in which information is to be displayed. The selected
language is used for screen text, labels, menus and options. Chart text,
provided by the chart card, is not affected.
Simulator
The simulator allows operation of the Raychart 425 without data from
external sources. The options are
ON or OFF.
When
ON is selected the simulator generates position, SOG and COG
data and uses the simulated data instead of any real data. A flashing
SIM
status indicator is displayed in the left hand corner of the Status Bar at the
top of the screen.
Note: The simulated data overrides any real data that the display unit is
receiving from externally connected equipment.
The position is initially the position of the cursor when the simulator is
switched on and the SOG and COG are as selected by the user. The
position is updated to reflect the SOG and COG. See Simulated SOG and
Simulated COG below.
If a GOTO or Follow is started, the simulator does not use the selected
value of COG but, instead, generates a value of COG that simulates the
navigation function in progress. When GOTO or Follow is stopped, the
user selected value of COG is used.
Simulated SOG
Use horizontal movements of the trackpad to adjust the value of SOG
which is adjustable in 1 knot intervals from 00 to 99.
The Default value is zero and the selected value is retained on power
down.
If the simulator is switched
OFF, the value is shown as dashes and no
adjustment is possible.