Raymarine Raychart 425 - 4.3 Chart Set Up Parameters

Chapter 4: Setting Up 4-5
Simulated COG
Use horizontal movements of the trackpad to adjust the value of COG
which is adjustable in 1° intervals from 000° to 359°. It wraps around
from 000 to 359 and from 359 to 000.
The Default value is zero and the selected value is retained on power
down.
If the simulator is switched
OFF, the value is shown as dashes and no
adjustment is possible.
4.3 Chart Set Up Parameters
The CHART SET UP function allows the chartplotter to be set up according
to your system configuration and your personal preferences.
➤ To set the Chart default parameters:
1. Press the
PAGE key to display the SET UP function bar (Figure 4-3):
Figure 4-3: Set Up Function Bar
2. Use the trackpad left/right to highlight the CHART SET UP function and
press
ENTER to display the Chart Set Up menu (Figure 4-4):
Figure 4-4: Chart Set Up Menu
D4694_1