Raymarine Raychart 425 - Stop Follow or Stop Goto; Changing the Display Mode

Chapter 3: Operation 3-23
Stop Follow or Stop Goto
➤ To stop following the route or target point:
1. Either press the
GOTO key or move the cursor over the target way-
point.
2. Select the
STOP GOTO or STOP FOLLOW function (Figure 3-38):
Figure 3-38: Stop Follow/Stop Goto Soft Keys
The dotted line from the vessel to the target waypoint disappears.
3.5 Changing the Display Mode
Use the PAGE key to select the required display mode. Repeat presses of
the
PAGE key provide the following display modes:
• Set Up functions (see Chapter 4)
• Course Deviation Indicator (CDI)
• Bearing & Distance Indication (BDI)
• Waypoint data
• Navigation data
• Time/Date data
• Return to Chart display
Note: Press
GOTO in any display mode to return to normal Chart dis-
play.
➤ To change the display mode:
1. Press the
PAGE key to show the SET UP functions with SYSTEM SET UP
highlighted (Figure 3-39):
Figure 3-39: Setup Function Bar
2. Repeat Step 1 to cycle through each of the available display modes.
Note: The Set Up Function Bar remains displayed in each display mode.
To remove the Set Up Function Bar, press
CLEAR.
D4689
_
1
STOP
GOTO
RESTART
XTE
D4688_1
STOP
FOLLOW
RESTART
XTE
WAYPOINT
ADVANCE
D4699_1
SYSTEM
SETUP
CHART
SETUP
TRACK
SETUP
GPS
SETUP