Raymarine Raychart 425 User Manual

4-6 Raychart 425 Chartplotter
3. Use trackpad up/down to highlight the required parameter, then use
trackpad left/right to select the required setting.
4. When the required values have been set, press
ENTER to clear the
menu and return to the set up function bar.
5. Press
CLEAR to clear the function bar and return to the normal dis-
play.
Note: To return all settings to their original factory settings, perform a
factory reset as described in Chapter 6.
Table 4-3 lists the Chart Set up parameters and their options, shows the
factory default setting and provides a space to make a note of the new
default setting. Each parameter is described in the following subsections.
Table 4-3: Chart Setup Parameters
Parameter Options
Factory
Default New Setting
ORIENTATION NORTH UP
COURSE UP
HEAD UP
NORTH UP
PLOTTER MODE OFF/ON ON
SHOW WAYPOINTS OFF/ON ON
WAYPOINT SYMBOL FISH, SCULL,
ANCHOR or X
X
AUTOZOOM OFF/ON ON
SCREEN AMPLIFIER OFF/ON ON
COG VECTOR OFF/ON OFF
ARRIVAL CIRCLE 0.01nm, 0.05nm,
0.1nm, 0.5nm
0.1nm
ANCHOR ALARM OFF, 0.01nm,
0.05nm, 0.1nm,
0.5nm
OFF
XTE ALARM OFF, 0.01nm,
0.05nm, 0.1nm,
0.3nm, 0.5nm
OFF
CHART TEXT OFF/ON ON
CHART BOUNDARIES OFF/ON ON
DEPTH CONTOURS
<5M
OFF/ON ON

Raymarine Raychart 425 Specifications

General

Brand	Raymarine
Model	Raychart 425
Category	GPS
Language	English