Raymarine Raychart 425 - Page 56

Chapter 3: Operation 3-29
When the Time/Date screen is first opened, the data relates to the current
day, unless there is no date information available. In this case the last date
is used. The vessel’s current position is used unless there is no GPS fix in
which case the cursor position is used and shown as a
USER SELECTED
position.
The position data can be either as selected by you, in which case the text
relating to the position is
USER SELECTED, or the current position in which
case the text is
VESSEL.
The (c) indicator only appears when the position has been user calibrated.
The Time and Date fields show the local current time and date.
The
TTG and ETA (WAYPOINT) data relates to the target waypoint. The TTG
and
ETA (ROUTE) data relates to the end of the route.
All data is based on the SOG towards the current target. If the SOG is
negative, or data is not available, these fields are replaced with dashes,
one per character.
➤ To display Sunrise/Sunset information for a different date:
1. If the Set Up functions are displayed, press
CLEAR to remove them;
press
ENTER to display the position functions (Figure 3-45).
Figure 3-45: Position Functions
2. Select PREVIOUS DAY or NEXT DAY as required to display Sun-
rise/Sunset information for a particular date.
3. Select
TODAY to return the display to current date.
➤ To set the position data manually:
1. Display the Position functions as described for Sunrise/Sunset dis-
play above (Figure 3-45).
2. Select
SET POSITION then either:
i.
VESSEL POSITION which sets the position to the current position of
the vessel, or
ii.
SELECT POSITION which enables specific Latitude/Longitude data
to be entered.
Use cursor left/right to select individual characters to edit.
Use cursor up/down to select the required character.
iii.Press
ENTER to complete, or CLEAR to abort, the change(s).
D4992_1
SET
POSITION
PREVIOUS
DAY
TODAY
NEXT
DAY