4-2 Raychart 425 Chartplotter
Figure 4-2: System Set Up Menu
3. Use trackpad up/down to move the highlight up or down the list.
4. When the required parameter is highlighted, use trackpad left/right to
step through the settings.
5. When the required values have been chosen, press
ENTER to imple-
ment the change and return to the set up function bar.
6. Press
CLEAR to clear the function bar and return to the chart display.
Note: To return all settings to their original factory settings, perform a
factory reset as described in Chapter 6.
Table 4-2 lists the System menus and their options, shows the factory
default settings and provides space to make a note of personal settings.
Each parameter is described in the following subsections.
Table 4-2: System Menu Options
Menu Item Options
Factory
Default New Setting
BEARING
MODE
MAGnetic/TRUE TRUE
KEY BEEP OFF/ON ON
DISTANCE
UNITS
NAUTICAL MILES (nm)
KILOMETERS (km)
STATUTE MILES (sm)
NAUTICAL
MILES
SPEED UNITS KNOTS
KILOMETERS PER HOUR
(KPH)
MILES PER HOUR (MPH)
KNOTS
To Next Page
Loading...
