MODULAR SAFETY INTEGRATED CONTROLLER MOSAIC
14 8540780 • 30/03/2016 • Rev.26
The MOSAIC master M1 includes a
USB 2.0 connector for connection to
a Personal Computer where
the (MOSAIC Safety Designer)
configuration SW resides.
A USB cable of the correct size is
available as an accessory ( ).
Figure 2 - USB 2.0 front panel connector
TECHNICAL DATA LABEL
MCM LABEL
Figure 3 - MCM
MOSAIC Configuration Memory (MCM)
A backup memory, called (optional)
can be installed in the MOSAIC master M1
and used to save the SW configuration
parameters.
The MCM is written a new
project is sent from the PC to the M1.
Always switch the M1 off before
logging on to/logging off from the
MCM.
Insert the card in the
(in the direction shown
in Figure 3 - MCM)
To perform the configuration of several
M1 modules without using a PC and the
USB connector, you can save the desired
configuration on a single MCM and then
use it to download data on the modules
M1 to be configured.
If the file contained in the MCM is not identical to the one contained in M1, an overwrite
operation that will permanently delete the configuration data contained in M1 will be
performed.
If the M1 unit is damaged, you can replace it with a new one; having already saved all the
configurations on the MCM, all you need to do is insert the MCM in the new M1 and
To Next Page
Loading...
Need help?
General
