MANUAL – REFLEX EZ-TRAC™ | 37
8.2.3.1 Stored surveys
For Multi Shot surveys that have been performed in both directions,
the into hole survey has the name as entered when starting up the
survey, and the out of hole survey has the same name with ‘_R’ at the
end. Example: Test and Test_R, as shown in the figure below.
When one of these twin surveys (e.g. Test or Test_R) is opened, the
corresponding twin survey is also opened.
Figure 25 Stored surveys
UP/DOWN Use the UP/DOWN keys to navigate between the stored surveys.
OK Use the OK key to open the active survey.
LEFT Use the LEFT key to return to the RESULTS menu.
8.2.3.2 Survey results
It is possible to register a Magnetic Reference, to be used for quality
verification in the
REFLEX™ EZ-COM unit.
When the results of a Single Shot or a Multi Shot survey are
displayed, the Azimuth value is blinking if the station is out of the
magnetic reference range (±1,000 nT and ±0.5 deg). A star (*) in front
of the Mag. Field and/or the Mag. Dip values indicates that the value
is out of range.
When the results of an Orientation survey are displayed, the Magnetic
Toolface value is blinking if the station is out of the magnetic
reference range. A star (*) in front of the Mag. Field and/or the Mag.
Dip values indicates that the value is out of range.
Note, if ‘No Reference’ has been set in the Magnetic Reference
function, magnetic interference verification will not be performed. In
this case, there will be no blinking value even if there is a magnetic
disturbance.
Note, the Magnetic Reference that is set when a survey is performed,
is saved in the data file of that survey. The saved reference applies
when that survey is opened via the RESULTS menu, even if another
reference has been set in the Magnetic Reference function. The
Magnetic Reference of a stored survey can be viewed and edited in
REFLEX™ SProcess.
To Next Page
Loading...
Need help?
General
