MANUAL – REFLEX EZ-TRAC™ | 55
9 Single Shot and Multi Shot
surveys
This chapter provides instructions on how to perform Single Shot and
Multi Shot surveys.
Note, Multi Shot is only available if the functionality has been
enabled, which requires a license key. For instructions on how to
enable Multi Shot functionality, please refer to section 8.2.1 Multi Shot
Enabler.
9.1 Preparation
Before the survey is started, you need to decide on what surveying
method to use. Your choice will impact on the equipment you need,
and some of the methods require further preparations before you can
get started.
Surveying methods are described in the chapter Surveying Methods.
9.2 Register magnetic reference
To be able to identify survey data that might have been destroyed by
magnetic interference, a magnetic reference should be registered.
Instructions for how to register a magnetic reference are provided in
section 8.2.4.2 Magnetic Reference.
9.3 Set up Single Shot
It is possible to run a new Single Shot survey, or add a Single Shot
measurement to an existing survey. The survey setup is slightly
different, which is described in separate sections below.
Set up Single Shot
1. From the MAIN menu, select Survey.
2. From the SURVEY menu, select Single Shot.
9.3.1 New Single Shot
Name and depth of the new Single Shot survey is entered.
To Next Page
Loading...
Need help?
General
