MANUAL – REFLEX EZ-TRAC™ | 96
REFLEX
™
EZ-COM License Key
The Multi Shot functionality in REFLEX™ EZ-COM is available as a
license key enabled option.
License Key
The license key is assigned to the serial number of each individual
REFLEX™ EZ-COM unit.
Serial Number
License Key
Multi Shot enabling instructions
In order to enable the Multi Shot functionality, you need the license
key which is assigned to your particular
REFLEX™ EZ-COM unit.
Example: In the figure below, the serial number is 0004.
Enable Multi Shot
1. From the MAIN menu, select Settings.
2. From the SETTINGS menu, select License Key.
3. Ensure that the displayed serial number of the unit is the same as
in the table above.
4. Enter the license key from the table above, by using the
LEFT/RIGHT keys to navigate to the desired character. The OK
key is used to select the active character.
5. If you made a mistake, select the arrow
to the right in the line
of characters and press the OK key to delete the last character.
6. When the license key is entered, use the DOWN key to go to OK
on the display.
7. Use the OK key to select OK on the display.
8. In the SETTINGS menu, use the LEFT key to return to the MAIN
menu.
9. Multi Shot should now be available in both the SURVEY and
RESULTS menus.
To Previous Page
Loading...
Need help?
General
