37
Cosmetic Care & Maintenance
PLUMBING CONNECTORS
All black plumbing connections to the red and blue fresh
water lines require special instructions when they are to
be removed or replaced. Be sure to turn off the water
before starting any plumbing repairs.
1. To remove a tee, 90 degree, or straight fitting first
remove the cap on the end of the fitting by using a slotted
screwdriver. Insert the screwdriver in the cap slot and
turn 90 degrees. Cap will release from the fitting.
To reinstall a plumbing connection to a water line make
sure the line is cut off square and the end is smooth.
This will aid in ensuring a leakproof connection.
1. Install the cap on the supply line. You may need to use
a slotted screwdriver to remove the cap from a new fitting.
2. Simply push the fitting on to the supply line until
pressure is felt. This ensures it is completly in the fitting.
3. Push the cap on the collar until it snaps in place.Turn
on the water pressure and check for leaks.
Note: With the connector in place, a movement between
the line and connector is normal.
2. Push the connector and collar together. Hold the collar
next to the connector with your finger. Pull and the
connector/collar will release itself from the water line.
Cap
Fitting
Hold End Of Fitting
With Fingers And Pull
Connector Free Of
Supply Line
Slotted
Screwdriver
To Next Page
Loading...
