10A-134
ENGINE AND CYLINDER BLOCK ASSEMBLY
Engine/gearbox assembly: Removal - Refitting
F9Q
10A
a Disconnect the connector (2) from the refrigerant cir-
cuit pressure sensor.
a Unclip:
-the refrigerant circuit pressure sensor wiring (3)
from the "condenser - evaporator" connecting pipe,
-the refrigerant circuit pressure sensor wiring from
the front end panel (4) .
a Move aside the refrigerant circuit pressure sensor
wiring.
a Remove:
-the retaining bolt (5) of the "compressor - conden-
ser" connecting pipe from the body,
-the bolt (6) from the "condenser - expansion valve"
connecting pipe bracket,
-the bolt (7) from the "compressor - condenser" con-
necting pipe bracket.
a Disconnect:
-the "condenser - expansion valve" connecting pipe
from the condenser,
-the "compressor - condenser" connecting pipe
from the condenser.
a Remove:
-the seal of the "condenser - expansion valve" con-
necting pipe,
-the seal of the "compressor - condenser" connec-
ting pipe.
a Insert the blanking plugs.
a Remove the bolt (8) from the intercooler air outlet pi-
pe.
a Remove the bolt (9) from the intercooler air outlet pi-
pe.
a Pull the clip (10) from the intercooler air outlet pipe.
a Disconnect the intercooler air outlet pipe.
a Move the intercooler outlet air pipe to one side.
135512 135739
135649
To Next Page
Loading...
