Renault F4R - Page 194

11A-20
TOP AND FRONT OF ENGINE
Crankshaft accessories pulley: Removal - Refitting
K4M
11A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Remove:
-the engine cover,
-the throttle valve (see 12A, Fuel mixture, Throttle
valve: Removal - Refitting, page 12A-17) ,
-the front right-hand wheel (see Wheel: Removal -
Refitting) (35A, Wheels and tyres),
- the front section of the front right-hand wheel arch
liner (see Front wheel arch liner: Removal - Re-
fitting) (55A, Exterior protection),
- the engine undertray bolts,
- the engine undertray,
- the accessories belt (see 11A, Top and front of
engine, Accessories belt: Removal - Refitting,
page 11A-7) .
a Remove the bolt (1) from the crankshaft position
sensor.
a Move the crankshaft position sensor aside.
Essential special tooling
Mot. 1489 TDC locating pin.
Mot. 1496 Tool for setting camshaft.
Mot. 1750 Addition to retaining cams-
haft setting tool Mot. 1496 .
Mot. 1487 Tool for removing the cams-
haft covers (57 mm diame-
ter).
Mot. 1488 Tool for removing the cams-
haft covers (43 mm diame-
ter).
Tightening torquesm
new bolt of the cranks-
haft accessories pulley
40 N.m + 145˚
±±
±±
15˚
lifting eye bolts 10 N.m
dipstick guide tube bolt 10 N.m
TDC pin plug 25 N.m
crankshaft position sen-
sor bolt
10 N.m
IMPORTANT
Wear protective gloves during the operation.
WARNING
Do not run the engine without the accessories belt
to avoid damaging the crankshaft accessories pul-
ley.
K4M, and 858 or 866
136549