11A-196
TOP AND FRONT OF ENGINE
Camshaft seal at timing end: Removal - Refitting
K9K
11A
a Fit a new camshaft seal on the camshaft.
1 - First fitting of the camshaft seal
a Fit the cover (12) and the collar nut (13) of the (Mot.
1632).
a Screw on the collar nut until the cover touches the
cylinder head.
a Remove:
- the collar nut from the (Mot. 1632),
- the cover from the (Mot. 1632),
- the stud of the (Mot. 1632),
- the protective sleeve.
21687-1
Note:
For camshaft seals delivered fitted to a protective
sleeve:
-do not remove the camshaft seal from its protec-
tive sleeve,
-fit the sleeve fitted with the camshaft seal on the
camshaft,
-push the protective sleeve towards the cylinder
head until the camshaft seal is in full contact with
the cylinder head,
-fit the seal on the camshaft by following the
recommendations below.
21687-2
21687-3
To Next Page
Loading...
