11A-206
TOP AND FRONT OF ENGINE
Oil decanter: Removal - Refitting
K4M
11A
a Use SUPER CLEANING AGENT FOR JOINT FA-
CES (see Vehicle: Parts and ingredients for the
repairwork) (04B, Consumables - Products) to
clean:
-the joint face on the oil separator if it is to be re-
used,
-the joint face on the rocker cover.
a Use SURFACE CLEANER (see Vehicle: Parts
and ingredients for the repairwork) (04B, Consu-
mables - Products) to degrease:
-the joint face on the oil separator if it is to be re-
used,
-the joint face on the rocker cover.
a Apply RESIN ADHESIVE (see Vehicle: Parts and
ingredients for the repairwork) (04B, Consuma-
bles - Products) using a stipple roller on the joint
face of the oil separator until the joint face is comple-
tely coated.
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit:
- the oil separator,
- new bolts on the oil separator.
a Refit:
- the oil separator,
WARNING
To ensure proper sealing, the gasket surfaces
must be clean, dry and not greasy (avoid any fin-
ger marks).
WARNING
Applying excess sealant could cause it to be
squeezed out when parts are tightened. A mix-
ture of sealant and fluid could damage certain
components (engine, radiator, etc.).
102738
K4M, and 848
134678
K4M, and 858 or 866
136587
To Next Page
Loading...
