12A-8
FUEL MIXTURE
Air flowmeter: Removal - Refitting
K9K
12A
REFITTING
I - REFITTING PREPARATION OPERATION
a parts always to be replaced: Air flowmeter seal
(11,04,06,26).
II - REFITTING OPERATION FOR PART
CONCERNED
a Refit the air flowmeter, fitted with a new seal.
a Connect the air flowmeter connector.
III - FINAL OPERATION
a Fit the air filter unit air outlet pipe.
a Connect the air filter box air outlet pipe to the air
flowmeter.
a Torque tighten the air filter box air outlet pipe clip
on the air flowmeter (5.5 N.m).
a Apply the after repair procedure using the diagnos-
tic tool :
-connect the diagnostic tool,
-Select "Injection computer",
-go to repair mode,
-display the "After repair procedure" for the compu-
ter selected,
-select "Air flowmeter" in the "List of components
stored by this computer" section,
-carry out the operations described in the "After re-
pair procedure" section.
K9K, and 834
To Next Page
Loading...
