13B-37
DIESEL INJECTION
High pressure pump: Removal - Refitting
K9K, and 830
13B
a
a Disconnect the fuel supply pipe union from the high
pressure pump (5) .
a Fit suitable blanking plugs on:
-the high pressure pump opening,
-the fuel supply pipe opening.
a Clean the fuel return unions on the high pressure
pump (see 13B, Diesel injection, Diesel injection:
Precautions for repair, page 13B-1) .
a Disconnect the diesel injector fuel return rail from the
high pressure pump (6) .
a Fit suitable blanking plugs on:
- the high pressure pump opening,
- the diesel injector fuel return rail opening.
a Position the engine at Top Dead Centre. The cams-
haft pulley hole (7) should be opposite the cylinder
head hole (8) .
WARNING
To avoid any corrosion or damage, protect the
areas on which fuel is likely to run.
135872
135872
107270
To Next Page
Loading...
