13B-76
DIESEL INJECTION
High-pressure pipe between the pump and rail: Removal - Refitting
K9K, and 830
13B
a
a Undo the injector rail nuts (10) .
a Remove the high pressure pipe (11) between the
high pressure pump and the injector rail.
a Place a suitable blanking plug on:
-the high pressure pump opening,
-the injector rail opening.
REFITTING
I - REFITTING PREPARATION OPERATION
a
a parts always to be replaced: High-pressure pipe
between the pump and rail (11,05,03,02).
II - REFITTING OPERATION FOR PART
CONCERNED
a Remove the blanking plug from:
- the high pressure pump opening,
- the injector rail opening.
135871
WARNING
Always hold the intermediate injector union in
place with a wrench when loosening the high
pressure pipes.
Do not damage the injector return nozzle.
20960
WARNING
Before fitting a new high pressure pipe, lightly
lubricate the nut threads with the oil from the
applicator provided in the new parts kit.
Be careful not to allow oil into the high pressure
pipe.
Do not lubricate high pressure pipes supplied
without an applicator, as these high pressure
pipes are self-lubricating.
WARNING
Do not remove the blanking plugs from each
component until the last moment.
Also, do not remove the components from their
packaging until they are to be fitted to the vehi-
cle.
To Next Page
Loading...
