Renault F4R - Page 845

19A-78
COOLING
Engine cooling fan assembly: Removal - Refitting
F9Q
19A
REMOVAL
I - REMOVAL PREPARATION OPERATION
a Position the vehicle on a two-post lift (see Vehicle:
Towing and lifting) (02A, Lifting equipment).
a Disconnect the battery (see Battery: Removal - Re-
fitting) (80A, Battery).
a Remove:
-the engine cover,
-the engine undertray bolts,
-the engine undertray,
-the front wheels (see Wheel: Removal - Refitting)
(35A, Wheels and tyres),
-the front section of the front wheel arch liners (see
Front wheel arch liner: Removal - Refitting)
(55A, Exterior protection),
-the front bumper (see Front bumper: Removal -
Refitting) (55A, Exterior protection),
-the headlights (see Front headlight: Removal -
Refitting) (80B, Headlights),
-the front bumper supports (see Front bumper
support: Removal - Refitting) (42A, Front upper
structure).
-the front impact cross member (see Front impact
cross member: Removal - Refitting) (41A, Front
lower structure),
a Remove:
-the bolts (1) of the engine wiring channel,
-the bonnet catch (see Bonnet latch: Removal -
Refitting) (52A, Non-side opening element mecha-
nisms).
a Remove the front end panel bolts (2) .
a Tilt the front end panel.
a Remove the intercooler outlet air outlet pipe (see
12B, Turbocharging, Intercooler air outlet pipe:
Removal - Refitting, page 12B-56) .
135647
135645
135646