PG-FP5 CHAPTER 4 PROGRAMMING GUI USAGE
R20UT0008EJ0400 Rev. 4.00 Page 59 of 240
Jul 15, 2010
(7) [Update Firmware] command
The [U
pdate Firmware] command updates the firmware. Refer to 3.4 Updating Programming GUI, Firmware
and FPGA and download the relevant update file before starting update.
Executing of this command displays the following dialog box.
Figure 4-22. [Update Firmware] Dialog Box
To continue the firmware update, click the OK button.
Clicking the Cancel button cancels the firmware update.
Clicking the OK button opens the [Open firmware file] dialog box.
Figure 4-23. [Open firmware file] Dialog Box
Select the firmware file “fp5_fw_vxxx.rec” and then click the O
pen button.
Caution1. Do not use FP5 firmware other than the one posted on the website; otherwise, a defect may
occur.
2. When a firmware of FP5 updates from V2.00 to V1.xx, a serial number of FP5 is erased.
And, FP5 can't operate in USB1.1. In addition, the other functions don't have any problem.
When FP5 revives, consult a Renesas Electronics sales representative or distributor.
To Next Page
Loading...
Need help?
General
