PG-FP5 CHAPTER 4 PROGRAMMING GUI USAGE
R20UT0008EJ0400 Rev. 4.00 Page 65 of 240
Jul 15, 2010
(9) [FP5 Manager] command
The [FP5 Manager] command sets the FP5 management functions. These functions include the following: The
password function, the upload prohibit function, the device setup prohibit function, the bank mode enable function,
the simple mode enable function, the checksum comparison function, and the reset terminal property switching
function.
When the [FP5 Manager] command is executed, the following dialog will be opened.
Figure 4-31. Welcome to FP5 Manager Dialog Box
Clicking Yes will open the following dialog box.
If a password is not registered, the dialog box in Fig. 4-32 will open.
If a password is registered, the dialog box in Fig. 4-33 will open.
Clicking No will close the dialog box.
Figure 4-32. Password setting Dialog Box
In order to register a password, input a password into the [PASSWORD] box and [Confirm PASSWORD] box, and
then click OK .
The password must be made up of up to eight alphanumeric characters. (Differences in upper and lower case are
not recognized.)
Clicking Cancel will close the dialog box.
To Next Page
Loading...
Need help?
General
