PG-FP5 CHAPTER 4 PROGRAMMING GUI USAGE
R20UT0008EJ0400 Rev. 4.00 Page 92 of 240
Jul 15, 2010
If [Block] is selected:
Specify the block range subject to command processing, using the [Start] and [End] drop-down lists. These lists
show the block numbers where flash memory in the target device is configured.
If [Area] is selected:
Specify the Area number range subject to rewrite processing by using the [Start] and [End] lists.
The [Start/End] lists display the Area number where the target device is configured.
[Show Address] check box
Specifies whether numbers or addresses are displayed in the Start/End lists. If this check box is checked,
addresses are displayed. If it is not checked, numbers are displayed.
[Selective programming/Verify/Read] check box
This item is not available.
<4> De
faults button
The default settings stored in the PR5 file are restored.
To Next Page
Loading...
