Renkforce RF2000 v2 Series User Manual

106
Test aborted Is displayed when the DMS test has been cancelled.
Formoreinformationontheerrorsthatoccurred,seethelogleoftheRepetier-Host.
SD Card removed Is displayed when the RF recognises that the SD card has been removed.
SD Card inserted Is displayed when the RF recognises that the SD card has been inserted.
SD Read Error Is displayed when the RF recognises that a reading error has occurred.
SDErrorxed Is shown when the RF has removed the reading error.
No SD Card IsdisplayedwhentheRFwantstodeletealefromtheSDcardbutthereisnoSDcard.
Uploading… IsdisplayedwhenaleistransferredtotheSDcard.
Heating up… Isdisplayedwhenthermwareiswaitingafterstartingtheheatbedscanuntiltheextruderand/ortheheatbed
has heated up.
Cooling down… Isdisplayedwhenthermwareiswaitingafterstartingtheheatbedscanuntiltheextruderand/ortheheatbed
has cooled off.
Outputting… Is displayed when Output Object is being executed.
Pausing… Is displayed when moving to the Pause-Position.
Continuing… Is displayed when moving to the Continue-Position.
Driving free Z Is displayed when Z-Max
- is cleared in the scope of Z-homing
- is cleared after the end of printing/milling
PID determined Is displayed when automatic determination of the PID-values has been successfully completed.
SERVICE Isdisplayedwhenthermwarendsatactivationthattheserviceintervalhasbeenreached(orexceeded).This
function is currently switched off by default.
Error messages
(AreeitherdisplayedintheprinterdisplayorinthelogleoftheRepetier-Hostsoftware)
Error:
Set Origin
Home unknown
Is displayed when the origin cannot be set because the home position is not known.
Can be caused by:
- G92
- M3115
-themenuitem"SetXYOrigin"
Error:
Heat Bed Scan
Operation denied
Is displayed when someone tries to start the heat bed scan while printing is active.
Can be caused by:
- M3010
- the menu item "Scan Heat Bed"
Error:
Heat Bed Scan
Saving failed
Is displayed when the determined matrix could not be saved after the heat bed scan.
This error theoretically should never happen.
Error:
Work Part Scan
Operation denied
Is displayed when someone tries to start the work piece scan while milling is active.
Can be caused by:
- M3150
- the menu item "Scan Work Part"
Error:
Work Part Scan
Saving failed
Is displayed when the determined matrix could not be saved after the work piece scan.
This error theoretically should never happen.
Error:
Output Object
Operation denied
Is displayed when someone tries to start output object while printing/milling is active.
Can be caused by:
- M3079
- the menu item "Output Object"
Error:
Output Object
Home unknown
Is displayed when the output object is not possible because the home position is not known.
Can be caused by:
- M3079
- the menu item "Output Object"
- when printing/milling from the SD card has been completed

Renkforce RF2000 v2 Series Specifications

General

Brand	Renkforce
Model	RF2000 v2 Series
Category	3D Printers
Language	English