5
3. Intended use
The 3D printerproducestwo-coloured3D-objectsfromsuitableprintingles.Forthis,suitablerawmaterial(lament)ismeltedinthetwoprint
heads and attached in the required position for the object.
This product is only approved for connection to 230 V/AC, 50 Hz alternating voltage.
It is intended for indoor operation only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be avoided under all circum-
stances.
Using the product for any other purposes than those described above may damage the product. Improper use also may cause dangers such
asshortcircuit,re,electricshock,etc.Readtheoperatinginstructionspreciselyandkeepthem.Onlypasstheproductontoanythirdparties
together with the operating instructions.
This product complies with the statutory national and European requirements. All company names and product names
are trademarks of their
respective owners. All rights reserved.
Arduino™isaregisteredtrademarkofArduinoS.r.l.anditsafliatedcompanies.
ATTENTION Mains voltage - the connection, installation and wiring of the electrical components must only be performed
by an electrician who is familiar with the applicable safety provisions. Before commissioning, inspection according to the
applicable safety provisions must be performed by an electrician. This also applies to repair work.
Observe all safe
ty and assembly notes in these operating instructions and in the assembly instructions!
Current operating instructions
Download the current operating instructions via the link www.conrad.com/downloads or scan
the displayed QR code. Follow the instructions on the website.
To Next Page
Loading...
Need help?
General
