Renkforce RF2000 v2 Series - 18 Software Repetier-Host; A) Connection of the Connected Printer

49
18. Software "Repetier-Host"
a) Connection of the connected printer
Start the programme Repetier-Host and click on "Printer Settings" at the upper right in the window.
• Selecttheprinterinthemenuabove(1).Inourexample,thisisthe"RF2000v2_3D_Dual" with dual extruder. Owners of the single version
must select the single version "RF2000v2_3D_Single" accordingly.
• Settheportandcheckthebaudrate.Ifyouhaveselectedtherightprinterin(1),thebaudrate(3)isalreadycorrectlypre-setto"115200".
The port number (2) is system-dependent.
Usually, the setting "Auto" should work with the
current version of the software (as of 2.0.5).
If this does not work properly for you, you can
check the port in the device manager of the con-
trol panel, under connections (COM and LPT).
Then set the COM-port from the device manager
in the software.
• Click"OK" (4).
1
3
4
2