Renkforce RF2000 v2 Series - D) Executing the Head Bed Scan for PLA or ABS

36
d) Executing the head bed scan for PLA or ABS
Thetextundertherespectiveguredescribeswhichbuttonsmustbepushedorwhatmustbesetwhenthisdisplayisshown.
Start of the heat bed scan
BrieypushthebuttonOK (2) in the main display. Use the direction buttons (1) to move to the menu item "Congura-
tion".
Push OK. Use the direction buttons to select "Z Calibration".
Push OK. Use the direction buttons to move to the menu item "Scan PLA" or
"Scan ABS" (depending on what materials you want to perform the
scan for).
Push OK, to select "Scan PLA" and start the heat bed scan for PLA
this way. Push the direction button "left" 3 x to return to the main
menu.
The printer now heats up the printing plate and both extruders auto-
matically(printingplatePLA=60°C,ABS=120°C;bothextruders
PLA = 100 °C, ABS = 100 °C).