Renkforce RF2000 v2 Series - 10 Required Tools and Material

13
10. Required tools and material
For use, calibration and maintenance
• Hexkeys2.5mm/3mm/4mm
• Externalhexkeysocketwrenches7mm/8mm
• Externalhexkeyopen-endedwrenches5.5mm/7mm/8mm/11mm
• Specialadhesivetapeinordertoimproveadhesionatcertainlaments(e.g.PLA);ourrecommendation:blueadhesivetape,Conradorder
no. 1093104
For possible repairs
• Differentscrewdrivers(cross-headandslotted)
• Hexkey1.5mm/2mm/2.5mm/3mm/4mm
• Externalhexkeysocketwrenches4mm/5.5mm/7mm/8mm
• Externalhexkeyopen-endedwrenches5.5mm/7mm/8mm/11mm
• Externalhexkeyopen-endedwrench(at)10mm
A hexagon socket wrench or a hexagon spanner may be used in some cases.
• Hammer
• Stopangle
• Calliper
• Wirecutter
• Combinationpliers,smallatpliersandsmalllong-nosepliers
• Threadlockervarnish,mediumstrength
• Feelergauge0.3mm,0.8mm,0.9mm1.0mm(recommendedupto1.0mmin0.05mmsteps)
• Hot-gluegun(optional)