Renkforce RF2000 v2 Series - C) Operation; D) Socket

9
c) Operation
• Pushtheemergencyoffswitchatonceifthereisanyelectricalormechanicalproblem!Theprinterwillbepowereddownbythis.
Only reset the emergency off switch when the problem has been removed.
• Neverreachintothe3Dprinterinoperation.Themechanicallymovedpartswithintheprinterposeahighriskofinjury!
• Theprintheadandtheprintingplategrowveryhotinoperation.Nevertouchthesepartsduringorjustafteroperation.Letthem
cooldownsufcientlyrst(approx.60minutes).
• Disconnectthedevicefromthemainsbeforemaintenanceworkormodications(unplugthemainsplug!)andletitcooldown.
• Inoperation,therewillbenoiseand,dependingonthelamentmaterialused,smells.Observethiswhenselectingthesiteofsetup
andthelamentmaterial.Ensuresufcientventilationorinstallanextractionsystem.Donotinhalearisingvapours.Whenusing
anyotherthantherecommendedlamentmaterial,poisonousvapoursorgasesmaydevelop.
• Donottouchthemainscableifitisdamaged.Firstpowerdowntherespectivemainssocketonallpoles(e.g.switchoffcircuit
breaker and FI switch) and then pull the mains cable from the socket. Never operate the product with a damaged mains line.
• Nevertouchthemainslineorthemainsplugwithwetordamphands.Thereisariskofpotentiallyfatalelectricshock!
• Neveroperatethedeviceunattended.
• Onlyoperatethedeviceinmoderateclimates,neverintropicalclimates.
d) Socket
• Thesocketontherearofthe3Dprinterservestoconnectsuitabledevices.Thesocketiscontrolledseparatelybythe3Dprinter
as required.
Never connect any other devices here that are not intended for operation in connection with the 3D printer.
• Donotoverloadthesocket.Themaximumpermittedoutputpowerisindicatedonthesocket(alsoseechapter"25.Technical
data").
• Themainscablemustnotbesqueezedordamagedbysharpedges.Donotputanyobjectsontothemainscableanddonotstep
on it. Place the mains cable so that no one can trip over it and that the mains lug is easily accessible.
Also place the mains cable so that there can be no damage when operating the 3D printer.
• Alwayspullamainsplugfromthesocketbytheprovidedgrip;neverpulloutamainsplugfromthesocketbythecable!
• Donotconnectinseries!Donotconnectanysocketstriptothesocketofthe3Dprinter.
• Donotoperatecovered!
• Voltage-freeonlywhentheplugispulled!Thesocketiscontrolledseparatelybythe3Dprinter.Themainsvoltagethereforemay
increase inadvertently.
 Forexample,ifyouwanttooperateadeviceviathe3Dprintersocket,rstpullthemainsplugofthedevicefromthe3Dprinter
socket before performing any work on it.