Renkforce RF2000 v2 Series - 23 Handling; 24 Disposal; 25 Technical Data

99
23. Handling
• Neverconnectthemainsplugtoamainssocketimmediatelyafterthedevicehasbeentakenfromacoldtoawarmenvironment.Theresult-
ing condensation may destroy the device. Allow the device to reach room temperature before connecting it. Wait until the condensation has
evaporated.
• Neverpullthemainsplugfromthemainssocketbythecable.Onlypullitfromthemainssocketbytheintendedgripareas.
• Disconnectthe3Dprinterfromthemainsvoltageifyouarenotgoingtouseitforanextendedperiodoftime.
• Disconnectthemainsplugfromthemainssocketduringthunderstormsforreasonsofsafety.
• Theheatingplateandtheextrudersmayheatupstronglyinoperation.Donottouchthesepartsduringorjustafteroperation.Lettheseparts
cooloffrst.Attention!Dangerofburns!
24. Disposal
The product does not belong in the household waste!
Dispose of the product according to the relevant statutory regulations at the end of its service life.
25. Technical data
Operating voltage ................................ 230 V/AC, 50 Hz
Power intake 3D printer ....................... max. 760 W
Connection output socket .................... max. 800 W
Total power intake ................................ max. 1560 W
Fuse ..................................................... T6.3AL/250 V (5 x 20 mm, slow-acting trigger)
Production process .............................. FFF (Fused Filament Fabrication) / FDM (Fused Deposition Modelling)
Printing space (W x D x H) .................. Singleextruderapprox.200x290x185mm(X,Y,Z)
............................................................. Dualextruderapprox.170x290x185mm(X,Y,Z)
Printing layer thickness ........................ 0.05 - 0.3 mm
Nozzle diameter ................................... 0.4 mm
Suitablelamentmaterial .................... ABS, PLA, PVA, EcoPLA™, PET, Taulman, Layrick, Bendlay, Laywood-D3, HIPS and smartABS
Filament diameter ................................ Standard, max. 1.75 mm
Power of the heating plate ................... 560 W
Extruder temperature ........................... 120–270°C
Heating plate temperature ................... 55–160°C
Interfaces ............................................. USB 2.0 and SD/SDHC card reader
Dimensions (W x D x H) ...................... 390 x 420 x 665 mm
Weight ................................................. 19.7 kg