Renkforce RF2000 v2 Series - E) Executing the Quick Head Bed Scan

39
e) Executing the quick head bed scan
Thetextundertherespectiveguredescribeswhichbuttonsmustbepushedorwhatmustbesetwhenthisdisplayisshown.
Heating up the printing plate and the extruders
BrieypushthebuttonOK (2) in the main display. Use the direction buttons (1) to select "Extruder".
Push OK. Push OK to select "Temp. Bed".
Use the direction buttons to set "100 °C". Push OK.
Use the direction buttons to select "Temp. 0". Push OK.
Use the direction buttons to set "120 °C". Push OK.