44
Push OK. Use the direction buttons to navigate to "Active Extruder".
Push OK. Then the 2nd extruder is chosen as the active one (ex-
truder 1).
Use the direction buttons to select the item "Temp. 1".
Push OK. Use the direction buttons to set "200 - 230 °C" (e.g. for PLA).
Push OK. Push the direction button "left" 2 x to return to the main menu.
Wait until the extruder is completely heated.
Then use the button "Filament feed +" (4) to insert and extrude the
lament.
Whenthelamentisinserted,switchbacktothemenu"Extruder"
and move to the menu item "Extruder 1 off".
Push OK, to switch off the extruder heater.
To Next Page
Loading...
