Renkforce RF2000 v2 Series - Page 71

71
(1) Thestartingcodecontainstherstcommandsthatthe3Dprinterperforms.Here,e.g.aZ-compensationcanbestarted.
The Z-compensation command then could be the following:
M3006 S-100 (-100 are 100 µm or 0.1 mm in this case)
  Ifthevalueisprexedwitha-,thedistancebetweenthenozzleandheatbedreduces.A+willincreaseit.
(2) The end code will be performed at the end of the print and could contain, e.g. the run into a removal position for the printed object.
Detailed information on the G-Codes can be found, e.g., in http://reprap.org/wiki/G-code.
FindaG-codebelowthatcontrolstheLEDlighting.Itcanbeintegrated,e.g.,intothestartcodeortheendcode.Youcanalsouseonlyparts
ofthis.Thecomment(afterthe;)sayswhatthecodedoes.
The RGB control must be set to "Manual" in the "Quick Settings" menu for this.
M3308P0;switchthelightsoff
G4S5;wait5seconds
M3308P1;switchthelightstowhite
G4S5;wait5seconds
M3307P1S255;settheredcomponentofthemanualcolourto255
M3307P2S0;setthegreencomponentofthemanualcolourto0
M3307P3S0;setthebluecomponentofthemanualcolourto0
M3308P3;switchtothemanualcolour(=red)
G4S10;wait10seconds
M3307P2S255;setthegreencomponentofthemanualcolourto255
G4S10;wait10seconds
M3307P1S0;settheredcomponentofthemanualcolourto0
G4S10;wait10seconds
M3307P3S255;setthebluecomponentofthemanualcolourto255
G4S10;wait10seconds
M3307P2S0;setthegreencomponentofthemanualcolourto0
G4S10;wait10seconds
M3307P1S255;settheredcomponentofthemanualcolourto255
G4S10;wait10seconds
M3307P3S0;setthebluecomponentofthemanualcolourto0
G4S10;wait10seconds
M3308P2;switchthelightstoautomatic
G4S10;wait10seconds
2
1