Renkforce RF2000 v2 Series - Page 85

85
Setting the determined values
Tosetthevalue,rstopentheitem"Conguration" in the menu and then the item "General".
Navigate to "Extruder Offset X" and press OK (2).
SetthedeterminedvaluefortheoffsetXwiththetwobuttons"up" and "down" (1).
ConrmwithOK button (2).
Navigate to the item "Extruder Offset Y" and press OK (2) again.
SetthedeterminedvaluefortheoffsetYwiththetwobuttons"up" and "down" (1).
ConrmtheselectionagainwiththeOK button (2).
When you have set the values, print the cube again and check the offset. If the layers of the 2 extruders are not precisely on top of
each other yet, correct the values and print out the cube again. Repeat this until the layers are precisely on top of each other.
If the layers of extruder 1 protrude on both sides, the extruders may not have the same height. In this case, perform a heat bed scan
and particularly observe when lowering the 2nd extruder that it is supported as well on the heat bed as the 1st extruder.