Ricoh Aficio MP C2050 Service Manual

Error Codes
D432/D433 16 SM
Code Meaning Suggested Cause/Action
Cable equalizer - G3 Switch 07 (PSTN)
Dedicated Tx parameters in Service Program
Mode
0-05
Modem training fails even
G3 shifts down to 2400
bps.
 Check the line connection.
 Try adjusting the tx level and/or cable
equalizer.
 Replace the FCU.
 Check for line problems.
Cross reference
See error code 0-04.
0-06
The other terminal did not
reply to DCS
 Check the line connection.
 Try adjusting the tx level and/or cable
equalizer settings.
 Replace the FCU.
 The other end may be defective or
incompatible; try sending to another machine.
 Check for line problems.
Cross reference
See error code 0-04.
0-07
No post-message
response from the other
end after a page was sent
 Check the line connection.
 Replace the FCU.
 The other end may have jammed or run out of
paper.
 The other end user may have disconnected
the call.
 Check for a bad line.
 The other end may be defective; try sending to
another machine.
0-08
The other end sent RTN or
PIN after receiving a page,
because there were too
many errors
 Check the line connection.
 Replace the FCU.
 The other end may have jammed, or run out of
paper or memory space.

Ricoh Aficio MP C2050 Specifications