Controller Options
SM 2-89 D037/D038/D040/D041
Installaion
is not guaranteed when such an SD card is used.
Hold down the lever [A] and turn it in the arrow direction.
Remove the inner cover [B] ( x 4), and then keep the SD card in the place [C] after
you copy the application program from one card to another card. This is done for the
following reasons:
1) The SD card can be the only proof that the user is licensed to use the application
program.
2) You may need to check the SD card and its data to solve a problem in the future.
You cannot copy PostScript application to another SD card. You have to copy the other
application (PictBridge, DOS Unit) to the SD card that stores the PostScript
application.
Move Exec
The menu “Move Exec” (SP5-873-001) lets you copy application programs from the original
SD card to another SD card.
Do not turn ON the write protect switch of the system SD card or application SD
card on the machine. If the write protect switch is ON, a download error (e.g. Error
Code 44) occurs during a firmware upgrade or application merge.
1. Turn the main switch off.
2. Make sure that an SD card is in SD Card Slot 1. The application program is copied to
this SD card.
3. Insert the SD card with the application program in SD Card Slot 2.The application
program is copied from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-001 “Move Exec.”
7. Follow the messages shown on the operation panel.
To Next Page
Loading...
Need help?
General Specifications
