Controller Options
D037/D038/D040/D041 2-98 SM
2. Install the Bluetooth board [A] (Knob-screw x 2) into the slot.
3. Insert the Bluetooth card [B] into the Bluetooth card adaptor.
4. Install the Bluetooth card adaptor on the Bluetooth board.
5. Attach the antenna cap to the Bluetooth board.
6. Make sure that the machine can recognize the option (see ‘Check All Connections’ at
the end of this section).
2.22.8 DATAOVERWRITESECURITY UNIT TYPE I (D362-11:
D038/D041 ONLY)
Accessory Check
Check the accessories and their quantities against the table below.
Description Q’ty
1. Data Overwrite Security SD Card Type I 1
2. Operating Instructions CD-ROM 1
3. Comments Sheet (17 languages) 2
Before You Begin the Procedure
1. Confirm that the DataOverwriteSecurity unit SD card is the correct type for the
machine. The correct type for this machine is "Type I".
2. Make sure that the following settings are not at their factory default values:
 Supervisor login password
 Administrator login name
 Administrator login password
If any of these settings is at a factory default value, tell the customer these settings
must be changed before you do the installation procedure.
⇒
Rev. 02/2009
To Next Page
Loading...
Need help?
General Specifications
