Ricoh Aficio MP C2050 Service Manual

Error Codes
D432/D433 20 SM
Code Meaning Suggested Cause/Action
not available
(V.8 calling and called
terminal)
was a V.34 data modem and not a fax
modem.)
 A polling tx file was not ready at the other
terminal when polling rx was initiated from the
calling terminal.
0-74
The calling terminal fell
back to T.30 mode,
because it could not detect
ANSam after sending CI.
 The calling terminal could not detect ANSam
due to noise, etc.
 ANSam was too short to detect.
 Check the line connection and condition.
 Try making a call to another V.8/V.34 fax.
0-75
The called terminal fell
back to T.30 mode,
because it could not detect
a CM in response to
ANSam (ANSam timeout).
 The terminal could not detect ANSam.
 Check the line connection and condition.
 Try receiving a call from another V.8/V.34 fax.
0-76
The calling terminal fell
back to T.30 mode,
because it could not detect
a JM in response to CM
(CM timeout).
 The called terminal could not detect a CM due
to noise, etc.
 Check the line connection and condition.
 Try making a call to another V.8/V.34 fax.
0-77
The called terminal fell
back to T.30 mode,
because it could not detect
a CJ in response to JM
(JM timeout).
 The calling terminal could not detect a JM due
to noise, etc.
 A network that has narrow bandwidth cannot
pass JM to the other end.
 Check the line connection and condition.
 Try receiving a call from another V.8/V.34 fax.
0-79
The called terminal
detected CI while waiting
for a V.21 signal.
 Check for line noise or other line problems.
 If this error occurs, the called terminal falls
back to T.30 mode.

Ricoh Aficio MP C2050 Specifications