Bit Switches
SM 59 D432/D433
D432/D433
Fax Option
Type
C2550/C2530
System Switch 0E [SP No. 1-101-015]
No FUNCTION COMMENTS
0-1
Not used
Do not change the settings.
2
Enable/disable for direct
sending selection
0: Direct sending off
1: Direct sending on
Direct sending cannot operate when the capture
function is on during sending. Setting this switch to
"1" enables direct sending without capture. Setting
this switch to "0" masks the direct sending function
on the operation panel so it cannot be selected.
3
Action when the external
handset goes off-hook
0: Manual tx and rx operation
1: Memory tx and rx operation
(the display remains the
same)
0: Manual tx and rx are possible while the external
handset is off-hook. However, memory tx is not
possible.
1: The display stays in standby mode even when
the external handset is used, so that other people
can use the machine for memory tx operation.
Note that manual tx and rx are not possible with
this setting.
4-7
Not used
Do not change these settings.
System Switch 0F [SP No. 1-101-016]
No FUNCTION COMMENTS
Country/area code for functional
settings (Hex)
00: France 11: USA
01: Germany 12: Asia
02: UK 12: Asia
03: Italy 13: Japan
04: Austria 14: Hong Kong
0-7
05: Belgium 15: South Africa
This country/area code determines the
factory settings of bit switches and RAM
addresses. However, it has no effect on the
NCU parameter settings and communication
parameter RAM addresses.
Cross reference
NCU country code:
SP No. 2-103-001 for G3-1
SP No. 2-104-001 for G3-2
SP No. 2-105-001 for G3-3
To Next Page
Loading...
Need help?
General Specifications
