001
Execution mode *ENG [0 to 2 / 0:OFF / 1/step]
Sets the scope of application for FB control pf the heat accumulated on the pressure
roller.
011
Time Out *ENG [0 to 500 / 10 / 1sec/step]
Sets the time between paper feed starting and temperature correction starting.
021 to
026
Sets the time until the pressure temperature is acquired from F GATE with normal speed
or low speed.
021 Delay:Standard Speed:FC:1 *ENG [0 to 20000 / 3862 / 1msec/step]
022 Delay:Standard Speed:FC:1 *ENG [0 to 20000 / 2712 / 1msec/step]
025 Delay:Low Speed:FC:1 *ENG [0 to 20000 / 8093 / 1msec/step]
026 Delay:Low Speed:FC:1 *ENG [0 to 20000 / 5783 / 1msec/step]
031 Delay:Standard Speed:FC:2 *ENG [0 to 20000 / 3862 / 1msec/step]
032 Delay:Standard Speed:FC:2 *ENG [0 to 20000 / 2712 / 1msec/step]
035 Delay:Low Speed:FC:2 *ENG [0 to 20000 / 8093 / 1msec/step]
036 Delay:Low Speed:FC:2 *ENG [0 to 20000 / 5783 / 1msec/step]
041 to
043
Sets the pressure temperature to calculate the temperature correction value. Lower limit
or Upper limit for temperature correction value.
041 Press Reference Temp.:FC *ENG [0 to 200 / 70 / 1deg/step]
042 Temp. Correction Lower Limit *ENG [-30 to 0 / -1 / 1 deg/step]
043 Temp. Correction Upper Limit *ENG [0 to 30 / 0 / 1deg/step]
051 to
052
Sets the coefficient to calculate the temperature correction value. Paper Type: Plain 1,
Plain 2, Thick 1, Thick 2 Thick3, Special 1, Special 2, Special 3, Envelop, or OHP.
051 Paper Thickness Coeff.:Plain1 *ENG [0 to 100 / 0 / 1/step]
052 Paper Thickness Coeff.:Plain2 *ENG [0 to 100 / 0 / 1/step]
101 to
103
Sets the pressure temperature (Bk) to calculate temperature correction value.
101
Press Reference Temp.:Bk
Normal
*ENG [0 to 200 / 70 / 1deg/step]
Main SP Tables-1
31
To Next Page
Loading...
