SP5-045-001
Specifies if the counting method used in meter
charge mode is based on developments or prints.
NOTE: You can set this one time only. You cannot
change the setting after you have set it for the first
time.
"0": Developments
Service Tel. No. Setting
SP No. Function Default
SP5-812-001
through 004
5812-002 programs the service station fax
number. The number is printed on the counter list
when the meter charge mode is selected. This lets
the user fax the counter data to the service station.
Settings for @Remote Service
• Prepare and check the following check points before you visit the customer site. For details, ask the
@Remote key person.
Check points before making @Remote settings
1.
The setting of SP5816-201 in the mainframe must be "0".
2.
Print the SMC with SP5990-002 and then check if a device ID2 (SP5811-003) must be correctly
programmed.
• 6 spaces must be put between the 3-digit prefix and the following 8-digit number (e.g.
xxx______xxxxxxxx).
• ID2 (SP5811-003) and the serial number (SP5811-001) must be the same (e.g. ID2:
A01______23456789 = serial No. A0123456789)
3. The following settings must be correctly programmed.
• Proxy server IP address (SP5816-063)
• Proxy server Port number (SP5816-064)
• Proxy User ID (SP5816-065)
• Proxy Password (SP5816-066)
4. Get a Request Number
Execute the @Remote Settings
1. Enter the SP mode.
2. Input the Request number which you have obtained from @Remote Center GUI, and then enter
[OK] with SP5816-202.
Mainframe Installation
47
To Next Page
Loading...
Need help?
General
